Adlink cPCIS-1100A Series Manuel d'utilisateur télécharger pdf (Page 11)

Getting Started • 7

CompactPCI Card Installation/Removal Procedure

1. Place the sub-system on a level surface or rackmount it. Remove the

blanking plates where required by undoing the retaining screws at each

end. Retain the blanking plates for possible future use. The system should

not be put into use without blanking plates for all empty slots, otherwise the

EMC will be compromised

2. Hold the SBC module, peripheral card or PSU module vertically. For PSU

modules, make sure that the handle is unlatched (i.e. that it is pulled

downwards) by first pressing on the locking button with your thumb.

3. Carefully insert the module into the desired slot by sliding the edges of the

board into the appropriate card guide rail. Take care to ensure correct

alignment of the card with the chassis during insertion to prevent damage

to the card and/or backplane.

4. Continue inserting the card until the handle engages with the chassis.

5. Pull upwards on the handle for final insertion. For PSU modules, ensure

that the locking button on the handle is fully latched into position.

Locking Button

Unlatched

Insert Module

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Adlink cPCIS-1100A Series Manuel d'utilisateur Page 11